| Resource |
Links
|
Description |
| 2011-04-07 |
| Product Guides |
|
Signal Routing & Protection
|
| 2011-04-05 |
| App Notes |
|
Delta-Sigma ADCs Replace Integrating ADCs for Panel Meters
|
| 2011-04-01 |
| App Notes |
|
Secure Access Control Through Challenge and Response Authentication
|
| 2011-03-31 |
| App Notes |
|
Diagnosing Automotive Faults with Class D Audio Amplifiers
|
| App Notes |
|
Digital Resistor Sets Operating Power for Laser Driver
|
| App Notes |
|
How to Calculate the CCEN Duration for the MAX9257/MAX9258 Programmable SerDes Chipset
|
| 2011-03-28 |
| App Notes |
|
Proper Power-Supply Jumper Settings for Evaluating the MAX9259/MAX9260 SerDes Chipset
|
| Product Guides |
|
Thermal Management
|
| 2011-03-25 |
| App Notes |
|
Using DS314xx Clock Synchronization ICs with 1Hz Input Clocks
|
| 2011-03-24 |
| App Notes |
|
Wide Input Flyback Converter Features 5V at 2.6A Output
|
| App Notes |
|
Differences Between Maxim's Advanced UART Devices
|
| App Notes |
|
High-Efficiency, Low Cost Flyback Converter Uses No Optocoupler Feedback
|
| App Notes |
|
Data Logging
|
| 2011-03-22 |
| App Notes |
|
Modes of Operation on the MAX9949 and MAX9950 Parametric Measurement Units
|
| 2011-03-21 |
| App Notes |
|
Using Gimpel's PC-lint with IAR Embedded Workbench and a MAXQ® Microcontroller
|
| 2011-03-16 |
| App Notes |
|
High-Performance Class 2 Powered Device (PD) is Customizable for Class 3 Designs
|
| App Notes |
|
78M661x Sensor Selection Guide
|
| 2011-03-14 |
| App Notes |
|
Lithium Battery Content in Maxim Products
|
| 2011-03-09 |
| App Notes |
|
Automotive USB Power
|
| App Notes |
|
Simple Detection Circuit Lowers Stress on LED Driver with Power-Line Dimming
|
| App Notes |
|
Avoid Design Misinterpretations that Put System Operation in Jeopardy
|
| 2011-03-08 |
| App Notes |
|
Test Results for Energy and Voltage Parallel Pick-Up and Line-In-Use Detection
|
| App Notes |
|
Reduce the Chances of Human Error: Part 2, Super Amps and Filters for Analog Interface
|
| App Notes |
|
Reduce the Chances of Human Error: Part 1, Power and Ground
|
| 2011-03-04 |
| App Notes |
|
Easy Modifications to Sustain a Design with the DS2409 MicroLAN™ Coupler
|
| Product Guides |
|
Real-Time Clocks
|
| 2011-03-03 |
| App Notes |
|
Programming the 73M2901CE Call Progress Monitor Filter
|
| 2011-03-02 |
| App Notes |
|
Precise Frequency Detector Modification and Special Tone Generation
|
| App Notes |
|
V.23 Operation Including PAVI
|
| App Notes |
|
V.42-LAPM Operation
|
| App Notes |
|
73M2901CE Caller ID Support
|
| App Notes |
|
Oops...Practical ESD Protection vs. Foolhardy Placebos
|
| App Notes |
|
73M2901CE Quasi-Synchronous Operation
|
| App Notes |
|
POS Fast Connect Operation
|
| App Notes |
|
Implementing Host Based HDLC Using Quasi-Synchronous Mode
|
| 2011-03-01 |
| App Notes |
|
Optimizing Transmission Levels with the 73M2901CE
|
| App Notes |
|
73M2901CE Canal+ Compatibility
|
| App Notes |
|
73M2901 Ring Detection Using Optocouplers
|
| 2011-02-28 |
| App Notes |
|
Using the New Features of the 73M2901CE
|
| App Notes |
|
Using the 73M2901CE DTMF Detector
|
| App Notes |
|
73M2901CE Line-In-Use/Parallel Pick Up Detection
|
| App Notes |
|
Software-Based Ring/LIU/PPU Detection
|
| 2011-02-25 |
| App Notes |
|
73M2901CE Programming the Imprecise Call Progress Monitor Filter
|
| App Notes |
|
Manufacturing with the 73M2901CE V.22bis Single Chip Modem
|
| 2011-02-24 |
| App Notes |
|
73M2901CE SMS and Half Duplex V.23 Operation
|
| 2011-02-23 |
| App Notes |
|
PHY107X Evaluation GUI Version 2.5 Users Guide
|
| App Notes |
|
PHY107x Evaluation GUI 1.6 Users Guide
|
| App Notes |
|
PHY1076-01 SFP Reference Design for 155-2448Mbps Applications
|
| App Notes |
|
Setting Up the IAR Embedded Workbench for Phyworks' Firmware
|
| App Notes |
|
PHY1070/PHY1075 Reference Firmware
|
| 2011-02-21 |
| App Notes |
|
EEPROM and FLASH Write Cycle Timing
|
| App Notes |
|
Using a Pre-Calibrated Temperature Sensor in PHY1070-Family SFP
|
| App Notes |
|
Reducing Bias Noise in PHY1075 Applications
|
| 2011-02-18 |
| App Notes |
|
Setting Up and Programming the PHY107x in Non-DDM Applications
|
| App Notes |
|
73M2901CE PTT Testing
|
| App Notes |
|
Microcontroller Based PHY1078 Reference Design
|
| 2011-02-17 |
| App Notes |
|
Generate Modulation Current LUTs for PHY2078 Based Optical Modules at Single Temperature
|
| App Notes |
|
PHY1066 and PHY1068 Thermal Considerations
|
| 2011-02-16 |
| App Notes |
|
Reverse Battery Charger Protection
|
| App Notes |
|
Calibrating a PHY2078-Based Optical Module at a Single Temperature
|
| App Notes |
|
Reduction of Current Consumption in Applications Using PHY107x
|
| App Notes |
|
Use of the PHY1040 IC for 125Mbps to 2.125 Gbps SFP Applications
|
| App Notes |
|
Design a Low Power Consumption Optical Module Using PHY1040
|
| App Notes |
|
Temperature Compensation using Bias and Modulation Current with PHY1078
|
| App Notes |
|
PHY1075-01 Matching Circuits for 4G TOSA
|
| App Notes |
|
Programming the Phyworks' PHY1070-Family Reference Designs
|
| 2011-02-15 |
| App Notes |
|
Preventing Clock Stretching in Phyworks' Reference Designs
|
| App Notes |
|
Microcontroller Controls Current-Loop AFE Protection
|
| 2011-02-10 |
| App Notes |
|
Battery/Charger Load Switch Approximates Ideal Diode
|
| App Notes |
|
Supervise and Power-Sequence a SoC
|
| App Notes |
|
Sense Multiple Pushbuttons Using Only Two Wires
|
| 2011-02-09 |
| App Notes |
|
Operating the 71M653X with External Serial SRAM
|
| App Notes |
|
Getting Started with 78M661x Energy Measurement SoCs
|
| App Notes |
|
Protect Current-Sense Amplifiers from Negative Overvoltage
|
| 2011-02-08 |
| App Notes |
|
71M6513 Standards Compliance Test Report
|
| App Notes |
|
Design for EMC
|
| App Notes |
|
Single-Supply Op Amp Forms Noninverting Level Shifter
|
| App Notes |
|
Using the 73M2901CE in a Teridian K-Series Application
|
| App Notes |
|
Using the Teridian 73M2901CE in 4-Wire and Leased Line Applications
|
| 2011-02-07 |
| App Notes |
|
True-Shutdown Circuit
|
| 2011-02-04 |
| App Notes |
|
71M6513 Harmonic Performance
|
| App Notes |
|
Teridian 71M65XX Using DC-Tolerant CTs by J&D Electronics
|
| App Notes |
|
Real Time Clock Compensation
|
| App Notes |
|
71M6513 Neutral Current Measurement
|
| App Notes |
|
71M6513 Harmonic Analysis
|
| App Notes |
|
71M6513 Broadband VARh Harmonic Performance
|
| App Notes |
|
Meter Design for Power Failure Events
|
| App Notes |
|
Programming Teridian Meter ICs
|
| App Notes |
|
6613_OMU_2+2S_URT_V100 Firmware Description Document
|
| 2011-02-03 |
| App Notes |
|
Connecting the VFLT Pin of the 71M6515H
|
| App Notes |
|
Code for Bank-Switching with the 653X-Series
|
| App Notes |
|
RTC Compensation
|
| App Notes |
|
EMC/EMI Design Guidelines for 71M65xx ICs
|
| App Notes |
|
How to Implement End-of-Conversion Detection in Maxim's Ambient Light Sensors
|
| 2011-02-02 |
| App Notes |
|
Negative-to-Negative Switch-Mode Converter Offers High Current and High Efficiency
|
| 2011-02-01 |
| App Notes |
|
71M651X Crystal Frequency Variations
|
| App Notes |
|
71M65XX with VITROPERM CTs
|
| App Notes |
|
71M651X Boot Loader
|
| App Notes |
|
71M651X Operation with Batteries
|
| App Notes |
|
The Real-Time Clocks of the 71M65XX Metering ICs
|
