The MAX2557 direct-conversion RF-to-bits radio receiver is designed for HSPA-FDD femto basestations in bands II and V. The device has dedicated receive paths to enable downlink activities in both bands. The MAX2557 also provides GSM monitoring capability in the U.S. cellular and U.S. PCS bands.
The unique RF-to-bits architecture of the MAX2557 integrates four LNAs with inputs/outputs internally matched to 50Ω, quadrature mixers, baseband anti-aliasing filters, programmable-gain RF and baseband amplifiers, fractional-N RF synthesizer, RF VCO, fractional-N frequency synthesizer for ADC sampling clock, and high-dynamic-range I/Q continuous-time sigma-delta ADCs. The sigma-delta modulators perform I and Q analog-to-digital conversion onto 1-bit digital streams. A programmable LVDS-like interface, with its own frac-N clock generation system, is used for the data transfer to the baseband/DSP, where the final decimation, equalization, and digital channel filtering are performed in compliance with the MAX-PHY digital section definition. Digital IP blocks are available from Maxim. The MAX2557 modes of operation are programmable by a 3-wire serial bus.
The MAX2557 is specified for operation in the extended -40°C to +85°C temperature range and is available in a 7mm x 7mm x 1.4mm fcLGA package with exposed pad (EP).
Key Features
Applications/Uses
Complete RF-to-Digital-Bits Radio Receiver Subsystem
Supports
HSPA-FDD Bands II and V Uplink
HSPA-FDD Bands II and V Downlink Monitoring
GSM Monitoring in U.S. Cellular and PCS Bands
TS25.104 Compliant
Compatible with UMTS1900 and UMTS850 Interference Environments
High-Dynamic-Range Continuous-Time Sigma-Delta ADCs Allow Simple AGC Implementation with Switched Gain States
MAX-PHY Digital Rx Interface with Single-Bit I/Q Bitstream, No Analog Signals
On-Chip Fractional-N Frequency Synthesizers for LO and Sampling Clock Generation
Dual-Buffered Reference Outputs to Drive Transmit IC and Baseband DSP
Programmable Rail-to-Rail GPO Pins Controlled by Serial Interface for External Component Control
Operation Controlled Entirely by 3-Wire Serial Interface, No Analog Control Signals Necessary
* Some packages have variations, listed on the drawing. "PkgCode/Variation" tells which variation the product uses. Note that "+", "#", "-" in the part number suffix describes RoHS status. Package drawings may show a different suffix character.
This product cannot be purchased through our web site. Contact factory for availability.
MAX2547 WCDMA/HSPA Band I RF-to-Bits Femto-Basestation Radio Receiver MAX2599 Femto Basestation Bits-to-RF Radio Transmitter MAX2597 Femto-Basestation Bits-to-RF Radio Transmitter
More Like This: View Product Families for Similar Products
