| Single-Chip Transceiver for DS3 and E3
|
| Performs Receive Clock/Data Recovery and
Transmit Waveshaping for DS3 and E3
|
| Jitter Attenuator can be Placed Either in the
Receive or Transmit Path
|
| Interfaces to 75 Coaxial Cable at Lengths Up to
380 Meters or 1246 Feet (DS3), or 440 Meters or
1443 Feet (E3)
|
| Uses 1:2 Transformers on Both Tx and Rx
|
| On-Chip DS3 (M23 or C-Bit) and E3 (G.751 or
G.832) Framer
|
| Built-In HDLC Controller with 256-Byte FIFO for
the Insertion/Extraction of DS3 PMDL, G.751 Sn
Bit, and G.832 NR/GC Bytes
|
| On-Chip BERT for PRBS and Repetitive Pattern
Generation, Detection and Analysis
|
| Large Performance-Monitoring Counters for
Accumulation Intervals of At Least 1 Second
|
| Flexible Overhead Insertion/Extraction Port for
DS3, E3 Framers
|
| Loopbacks Include Line, Diagnostic, Framer,
Payload, and Analog with Capabilities to Insert
AIS in the Directions Away from Loopback
Directions
|
| Integrated Clock Rate Adapter to Generate the
Remaining Internally Required 44.736MHz (DS3)
and 34.368MHz (E3) from a Single-Clock
Reference Source
|
| CLAD Reference Clock can be 44.736MHz,
34.368MHz, 77.76MHz, 51.84MHz, or 19.44MHz
|
| Software Compatible with DS3171-DS3174 SCT
Product Family
|
| 8-/16-Bit Parallel and Slave SPI Serial (<10Mbps) Microprocessor Interface
|
| Low-Power (0.5W) 3.3V Operation (5V Tolerant
I/O)
|
| 100-Pin Small 11mm (1mm) CSBGA and 14mm
(1.4mm) LQFP Package Options
|
| Industrial Temperature Operation: -40°C to +85°C
|
| IEEE1149.1 JTAG Test Port |
Download
E-Mail