The MAX8513/MAX8514 integrate a voltage-mode
PWM step-down DC-DC controller and two LDO controllers,
a voltage monitor, and a power-on reset for the
lowest-cost power-supply and monitoring solution for
xDSL modems, routers, gateways, and set-top boxes.
The DC-DC controller switching frequency can be set
with an external resistor from 300kHz to 1.4MHz, to allow
for the optimization of cost, size, and efficiency. For noisesensitive
applications, the DC-DC controller can also be
synchronized to an external clock, minimizing noise interference.
Operation above 1.1MHz reduces noise for high
data-rate xDSL applications. An adjustable soft-start and
adjustable foldback current limit provide reliable startup
and fault protection. The DC-DC controller output voltage
can be set externally to a voltage from 1.25V to 5.5V.
Current limiting is accomplished by inductor current sensing
for improved efficiency, or by an external sense resistor
for better accuracy.
The MAX8513/MAX8514s' first LDO controller is
designed to provide a low-cost, high-current regulated
output from 0.8V to 5.5V using an N-channel MOSFET or
a low-current output using a low-cost NPN transistor. The
MAX8513's second regulator can be used to generate
0.8V to 27V output with a low-cost PNP transistor. Both
LDO regulators can operate either from the DC-DC controller
output or from a higher voltage derived with a flyback
overwinding on the DC-DC converter inductor. The
MAX8514's second LDO regulator is designed to provide
a negative output with an NPN transistor.
A sequence input allows the outputs to either power up
together, or for the DC-DC regulator to power up first
and each LDO controller to power up in sequence. An
input power-fail output (PFO-bar) is provided for input
power-fail warning, such as in dying-gasp applications.
A power-on reset circuit with a 140ms delay is also
included to indicate when all outputs have achieved
regulation and stabilized.
* Some packages have variations, listed on the drawing. "PkgCode/Variation" tells which variation the product uses. Note that "+", "#", "-" in the part number suffix describes RoHS status. Package drawings may show a different suffix character.
Devices:
1-7 of 7
MAX8513
Free Sample
Buy
Status
Package:
TYPE PINS FOOTPRINT
DRAWING CODE/VAR *
Temp
RoHS/Lead-Free? Materials Analysis
MAX8513EEI+
Active
QSOP;28 pin;61.9 mm²
Outline Drawing: 21-0055 (PDF)
Land Pattern: 90-0173 (PDF)
Use pkgcode/variation: E28+1*
Download
E-Mail