The DS2890 is a linear taper digitally controlled potentiometer with 256 wiper positions. Device operation, including wiper position, is controlled over the single contact 1-Wire bus for the ultimate in electrical interface simplicity. With a wide 0–11 volt working voltage range for the potentiometer terminals, the DS2890 is ideal for a broad range of industrial and control applications. Potentiometer terminal voltage is independent of device supply voltage as well as the voltage applied to the other potentiometer terminals. Communication with the DS2890 follows the standard Dallas Semiconductor
1-Wire protocol and can be accomplished with minimal hardware such as a single port pin of a microcontroller. Multiple DS2890 devices can reside on a common 1-Wire bus and be operated independently of each other. Each DS2890 has its own unalterable 64-bit ROM registration number that is factory lasered into the chip. The registration number guarantees unique identification for absolute traceability and is used to address the device in a multi-drop 1-Wire Network environment. The DS2890 will respond to a 1-Wire Conditional Search command if the potentiometer wiper is set at the power-on
default position. This feature enables the bus master to easily determine whether a potentiometer has gone through a power-on reset and needs to be re-configured with a required wiper position setting. The DS2890 supports two power modes: a) 1-Wire only mode in which device power is supplied parasitically from the 1-Wire and b) VDD mode where power is supplied from an external supply With a VDD supply the device can support both a potentiometer and variable resistor configuration. When operating in a 1-Wire only power mode the device supports only a variable resistor configuration.
Key Features
Single element 256-position linear taper
potentiometer
Supports potentiometer terminal working
voltages up to 11V
Potentiometer terminal voltage independent
of supply voltage
Potentiometer wiper position controlled and
read over minimal 1-Wire bus interface
100 kΩ resistor element value
T0-92 package provides a 1-Wire® variable
resistor configuration
Supports Conditional Search based on
power-on default wiper position
Multiple DS2890's can be identified on a
common 1-Wire bus and operated
independently
Unique factory lasered 64-bit registration
number assures error free device selection
and absolute part identity
Built-in multi-drop controller ensures
compatibility with other 1-Wire Network
products
Supports Overdrive mode which boosts
communication speed up to 142 kbits per
second
* Some packages have variations, listed on the drawing. "PkgCode/Variation" tells which variation the product uses. Note that "+", "#", "-" in the part number suffix describes RoHS status. Package drawings may show a different suffix character.
Download
E-Mail
