Search Results: mV

Build High-GBW Op-Amp From A Dual Video Amplifier - Maxim [Open results in new window]
... V IN, V OUT. +30.000mV, +2.968V. +20.000mV, +1.963V. +10.000mV, +0.960V. 0.000mV,
-0.046V. -10.000mV, -1.060V. -20.000mV, -2.070V. -30.000mV, -3.059V. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/7 - 21k

Improve Current Measurement Accuracy by Skewing the Input Offset ... [Open results in new window]
... The MAX4080 has a precision ±0.6mV (max) input offset voltage (V OS ) at 25°C, and
±1.2mV (max) V OS over the -40°C to +125°C temperature range. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4170 - 28k

CDMA 애플리케이션용 MAX2206/MAX2208 전력 검출기 ... [Open results in new window]
... 836MHz, 1880MHz. P IN (dBm), V OUT (mV), Ripple Noise (mV PP )¹, V OUT (mV), Ripple
Noise (mV PP )¹. 15, 1606, 44, 1643, 49. 13, 1247, 36, 1291, 35. 11, 965, 29 ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1013 - 29k

Understanding Analog Video Signals - Maxim [Open results in new window]
... NTSC, PAL. Setup, 53.6 mV, Setup, 0 mV. R'G'B', 714 mV (Peak Luma, 100% White),
R'G'B', 700 mV (Peak Luma, 100% White). Sync, -286 mV, Sync, -300 mV. ... Setup, 0 mV ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1184 - 55k

REP039: The MAX2510 IF Transceiver with the MAX5183 DAC - Maxim [Open results in new window]
... Q Offset Voltage (mV). LO Level (dBc). I Offset Set for Minimum (mv). SA Ref. ... I Offset
Voltage (mV). LO Level (dBc). Q Offset Set for Minimum (mv). 0. -44. -1. 3 ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1835 - 30k

DC 오프셋 전압이 있을 경우의 MAX2510 I/Q 변조기 ... [Open results in new window]
... 오프셋 전압 Vary just the Q OFFSET, Q OFFSET voltage (mV), LO level (dBc), I OFFSET
set for minimum (mV), SA Ref. level, LO, VQ pp, V BIAS, VGC. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1737 - 27k

Precision Instrumentation Amplifiers with Rejustors Solve High ... [Open results in new window]
... In some conditions the differential signal coming from the sensor is in the order
of very few mV, while the amplifier gain can be as high as 1,000. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4321/ - 32k

Implementing a MAX1385-Based Control Loop in C/C++ - Maxim [Open results in new window]
... The voltage on PGAOUT1 regulates between 20.8mV and 21.7mV, which is a variation
of 0.45mV (2%) around an average of 21.25mV. Source Code Walk-Through. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4065 - 26k

WCDMA에 적합한 190MHz IF의 MAX2309/MAX2312 - Maxim [Open results in new window]
... 표 1. 이득 측정 Pin (dBm), Vin_RMS (mV), Vagc (V), Differential Vop-p (Q) (mV),
Gain (dB). -5, 397.63536, 1.21400, 50, -27.04. -10, 223.60680, 1.24900, 50, -22.04 ...
korea.maxim-ic.com/appnotes.cfm/an_pk/902 - 34k

Storing Battery Fuel Gauge Parameters in DS2780 - Maxim [Open results in new window]
... state. This is an unsigned register with an LSB value of 19.52mV. ... 50µV. It
is stored in Address 65h, and has a range of 0 to 12.75mV. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3584 - 28k

Storing Battery Fuel Gauge Parameters in the DS2781 - Maxim [Open results in new window]
... state. This is an unsigned register with an LSB value of 39.04mV. ... 50µV. It
is stored in Address 65h and has a range of 0 to 12.75mV. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3727 - 30k

Using Analog Temperature Sensors with ADCs - Maxim [Open results in new window]
... 2.5V/1024LSBs = 2.44mV/LSB. The nominal slope of the MAX6605 temperature
sensor's output is 11.9mV/°C, so each LSB will correspond to ...
korea.maxim-ic.com/appnotes.cfm/an_pk/571 - 24k

Design Guidelines for High-Performance, Multichannel, Simultaneous ... [Open results in new window]
... of Channels, No. of Bits, V REF (V), LSB (mV), Quantization Noise (mV), SNR (dB). ...
A 1ppm/°C reference will drift by only 0.2mV over 50°C (or just ±3 LSBs). ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4359 - 49k

CATV dBm, dBmV 및 dBµV 간 변환 - Maxim [Open results in new window]
... 일반적인 정의에 의하면, dBmV는 1mV RMS 를 기준으로 하고 있으며
출력 전압(V OUT )은 mV RMS (식 1)로 측정된다. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/808 - 49k

2셀 배터리 애플리케이션의 호스트 사이드에서 ... [Open results in new window]
... Capacity (%), Cell Voltage (V), Δ Capacity (%), Δ Voltage (mV), Δ Capacity/Δ Voltage,
Max V IN Error (mV), Max Capacity Error (%), Max Current (µA), Max V IN ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4224 - 27k

Controlling a Variable Voltage Power Supply Using the DS1809 ... [Open results in new window]
... and a 220kΩ 1/8 watt resistor, we get the circuit in Figure 1. The .5V range divided
by the 64 positions provided by the DS1809 gives us 7.8mV/step from 5.0V ...
korea.maxim-ic.com/appnotes.cfm/an_pk/183 - 26k

High-Frequency Switching IC Powers Portable Telephone - Maxim [Open results in new window]
... Output Capacitance, Load Resistance, 1mΩ, 100kΩ, 10kΩ, 1kΩ. C2 = 0.1µF, -V OUT
(V) I + (mA) M RIPPLE (mV PP), 4.95 2.29 60, 4.92 2.34 60, 4.88 2.78 70, 4.56 6.60 ...
korea.maxim-ic.com/appnotes.cfm/an_pk/577 - 21k