Search Results: Through-Hole

T1/E1 and T3/E3 Transformer Selection Guide - Maxim [Open results in new window]
... Pulse, PE-65388, 1:1.15CT, TX only, Through Hole, 6, 0°C to +70°C, T1/E1, DS2151,
DS2152, DS2153, DS2154, DS21552, DS21Q552, DS21554, DS21Q554. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/351 - 63k

Considerations for Maxim Real-Time Clock Crystal Selection - Maxim [Open results in new window]
... Through-Hole Leaded Crystals. There are three common packages for through-hole leaded
crystals. ... Figure 2. Package for through-hole leaded crystals. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/616 - 44k

Prototyping with Surface Mount Devices - Maxim [Open results in new window]
... Many engineers and technicians are comfortable with through-hole devices, perforated
fiberglass boards, IC sockets, and wire-wrap or point-to-point wiring. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1110 - 23k

T3/E3/STS-1 LIU Secondary Surge Protection Design - Maxim [Open results in new window]
... mount. MUR1100E, On Semiconductor, Through-hole. F1, F2, 1.25A slow blow fuse, SMP
1.25, Bel Fuse, ... PE-65969, Pulse Engineering, Through-hole. TG07 ...
korea.maxim-ic.com/appnotes.cfm/an_pk/398 - 30k

[PDF] Maxim EJ2.K [Open results in new window]
... 0.001 0.01 0.1 1 10 100 1000 10000 FREQUENCY (Hz) THD+N (%) THROUGH-HOLE B CASE
A CASE C CASE THD+N vs. ... THD+N (%) 0603 0805 1206 THROUGH-HOLE THD+N vs. ...
pdfserv.maxim-ic.com/kr/an/AK0212K.pdf

Real-Time-Clock Selection and Optimization - Maxim [Open results in new window]
... crystal. Recommended layouts for surface-mount crystals and through-hole,
leaded crystals are shown in Figures 2 and 3, respectively. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/617 - 36k

Thermal Characterization of IC Packages - Maxim [Open results in new window]
... Junction-to-Board JESD51-9: Test Boards for Area Array Surface Mount Package Thermal
Measurements JESD51-10: Test Boards for Through-Hole Perimeter Leaded ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4083 - 31k

[PDF] Application Note: [Open results in new window]
... 이러한 경우 일반적으로 광 소자를 PCB의 상단에 실장하고, 핀을 구부려
PCB에 삽입하여 스루 홀 (through-hole) 연결을 만든다 ...
pdfserv.maxim-ic.com/kr/an/AN3516K.pdf

Migrating from the MAX7219 and MAX7221 to the MAX6950 and MAX6951 ... [Open results in new window]
... Yes. No. Interface logic input thresholds, Low: 0.8V max, high: 3.5V min. Low:
0.4V max, high: 2.4V min. Through-hole package, 24 narrow DIP. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/876 - 38k

Circuit Provides Reverse-Battery Protection - Maxim [Open results in new window]
... IC 1 's miniature 10-pin µMAX package takes less space than four through-hole signal
diodes and is almost as small as two SOT-23 dual signal diodes. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/480 - 20k

Why Maxim Chose to Design the Single-Piece NV SRAM Modules - Maxim [Open results in new window]
... Cell Batteries: Predicting an Application Lifetime." The "Brick"—Through-
Hole Components. Early hybrid module packaging concepts ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3693 - 33k

Off-The-Shelf Transformer Adapts Controller For SLIC Applications ... [Open results in new window]
... To reduce this ripple, increase the capacitor values and use through-hole filter
capacitors with low equivalent series resistance, such as the Sanyo MV-GX ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1001 - 21k

MAX3656: GPON / GEPON ONT 애플리케이션에서 긴 레이저 ... [Open results in new window]
... 이러한 경우 일반적으로 광 소자를 PCB의 상단에 실장하고, 핀을 구부려
PCB에 삽입하여 스루 홀 (through-hole) 연결을 만든다 ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3516 - 19k

How to Use a PC's Parallel Port to Communicate with 2-Wire Devices ... [Open results in new window]
... Key. The interface may be built using either surface-mount or through-hole
components. Figure 1. 2-wire parallel port interface. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3230 - 41k

수동 부품은 휴대용 장치의 오디오 품질을 ... [Open results in new window]
... 설정에서의 해상도 한계 및 일반적으로 휴대용 설계에 사용되지 않는
25V 스루 홀 (through-hole) 폴리에스테르 커패시터가 ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3171 - 37k

MAX2242 전력 증폭기: 중요한 애플리케이션 내용들 ... [Open results in new window]
... 상부 접지는 다중, 도금 도통 홀 비아(multiple,plated through-hole
vias)를 사용하여 하부 접지에 연결시켜야 한다. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1990 - 30k

Design Considerations for All-Silicon Delay Lines - Maxim [Open results in new window]
... Three lead-forming options are available: Straight lead: This is the conventional
package and is used for through-hole mounting in PCBs. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/14 - 33k

WiFi 트랜시버의 전원 및 접지 설계 - Maxim [Open results in new window]
... 상단 레이어 접지에서 접지 플레인으로 비아(through-hole or via)를
드롭시키는 것이 이 작업을 위한 일반적인 솔루션이다. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3630 - 36k