Search Results: Temperature Comparator

Dual Comparator Forms Temperature-Compensated Proximity Detector ... [Open results in new window]
Simple comparator and op amp circuit forms a temperature-compensated proximity detector. ...
Dual Comparator Forms Temperature-Compensated Proximity Detector. ...
korea.maxim-ic.com/appnotes.cfm/appnote_number/1903 - 25k

Distributed Temperature Sensing Improves Reliability - Maxim [Open results in new window]
... The MAX6501 "thermal switch" is a temperature comparator with a factory-set threshold,
available in 10°C increments from -45°C to +115°C. Its open-drain ...
korea.maxim-ic.com/appnotes.cfm/an_pk/687 - 35k

Dual Comparator Thermally Protects Li+ Battery - Maxim [Open results in new window]
A dual comparator and thermistor set safe temperature limits
for a lithium-ion battery charging circuit. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/2769 - 21k

Simple Circuit Protects Systems from Overheating - Maxim [Open results in new window]
... When system temperature increases above 45°C, IC1's factory-programmed temperature
comparator causes the Active-Low FANOUT fan drive pin to go active, pulling ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1126 - 21k

Selecting the Right Comparator - Maxim [Open results in new window]
... For the MAX917 and MAX9117 comparator families, for example, the maximum I BIAS
current is 2nA over the entire temperature range, and less than 1nA at room ...
korea.maxim-ic.com/appnotes.cfm/an_pk/886 - 41k

Comparator/DAC Combinations Solve Data-Acquisition Problems ... [Open results in new window]
... When a temperature change causes the comparator to trip, the comparator sends
an interrupt to the processor that initiates corrective action. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/647 - 40k

How to Simplify the Interface between Microcontroller and ... [Open results in new window]
... For example, the MAX6654 monitors a remote-junction temperature with a window
comparator and interrupts the µC when temperature goes above or below the limit ...
korea.maxim-ic.com/appnotes.cfm/an_pk/685 - 33k

Portable Temperature Monitoring Demystified - Maxim [Open results in new window]
... comparator into its linear region and a 1MΩ resistor buffers the crystal from the
output swings of the comparator. Figure 2. The temperature sensor, processor ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1754 - 41k

Temperature Sensor ICs Simplify Designs - Maxim [Open results in new window]
... In this case, the "plus" added to the analog temperature sensor is nothing
more than a comparator and a voltage reference. Other ...
korea.maxim-ic.com/appnotes.cfm/an_pk/694 - 37k

Comparison of the DS18B20 and DS18S20 1-Wire® Digital ... [Open results in new window]
... Table 4. Scratchpad Memory Map Comparison, DS18S20, DS18B20. byte 0, Temperature
LSB (AAh), Temperature LSB (50h). byte 1, Temperature MSB (00h), Temperature MSB ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4377 - 26k

Gamma-Photon Radiation Detector - Maxim [Open results in new window]
... A graph (Figure 2) shows the result of a typical gamma strike. The top waveform
is from Test Point 1, and the bottom waveform is the comparator output. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/2236 - 25k

PWM Outputs Enhance Sensor-Signal Conditioners - Maxim [Open results in new window]
... ratiometric circuit compensates the sensor over the entire temperature range, to
an ... basic blocks required are a triangular-waveform generator and a comparator. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1860/ - 29k

Add Fault Protection to 4-20mA Loop Supply - Maxim [Open results in new window]
... The selected fault-current trip point (for U1's internal comparator #1) is set by
the R2-R3 voltage divider at 0.6V. Setting the trip point for a 50mA fault ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3195 - 22k

Measuring the Output Jitter of the MAX999 Comparator - Maxim [Open results in new window]
... Near its switching point, a comparator behaves similar to an amplifier; specifically,
the gain of the comparator stages makes the output switch as a ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4061 - 28k

Understanding Flash ADCs - Maxim [Open results in new window]
... 0"s. The point where the code changes from ones to zeros is the point where the
input signal becomes smaller than the respective comparator reference voltage ...
korea.maxim-ic.com/appnotes.cfm/an_pk/810 - 33k