Search Results: Smart Battery

Choices for Battery-Charging System Architecture - マキシム [Open results in new window]
... the interface between portable products, batteries, and chargers ... deciding to use
a Smart Battery, it is possible to implement a Smart Charger using inexpensive ...
japan.maxim-ic.com/appnotes.cfm/an_pk/981 - 22k

Versatile ICs Enable Chemistry-Independent Battery Charging ... [Open results in new window]
... Smart Batteries. ... A smart charger is unnecessary, but the battery pack must be
intelligent. Thus, the battery pack in an SBS "knows" the charging algorithm it ...
japan.maxim-ic.com/appnotes.cfm/an_pk/666 - 32k

Harnessing Solar Power with Smart Power-Conversion Techniques ... [Open results in new window]
... Harnessing Solar Power with Smart Power-Conversion Techniques. ... This input is adequate
to start the converter ... acid batteries, could sense the battery current and ...
japan.maxim-ic.com/appnotes.cfm/an_pk/484 - 36k

[PDF] Products CD [Open results in new window]
... 3 図1. 一般充電器状態図 INITIALIZE CHARGER OK BATTERY INSTALLED NO CELL REQUEST
BATTERY OK FAST- TERMINATION CONDITIONS TERM ERROR ERROR ERROR ...
pdfserv.maxim-ic.com/jp/an/AN680J.pdf

The MAX1802 for Digital Still Camera from 2AA Batteries ... [Open results in new window]
... be separated from the main battery supply to save battery life ... In systems with only
2AA batteries, but using a back ... MAX1833 helps to power the MAX1802 at start-up ...
japan.maxim-ic.com/appnotes.cfm/an_pk/909 - 22k

Maximicro: Using Maxim's Smart ADC to Compensate Sensors ... [Open results in new window]
... in voltage regulator (use any 6 to 12V battery or wall ... Photo 1. They call it a smart
ADC, and the MAX1460 ... Conversion can also be initiated with the START pin. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/885 - 39k

Design Considerations for Data-Lump Cables - マキシム [Open results in new window]
... connectivity inherent in next-generation smart phones, and ... an increase in current
draw from the battery. ... 3.0V, and the part without decoupling fails to start. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/739 - 42k

[PDF] Products CD [Open results in new window]
... GND THM 0.1HF 0.022HF INTERRUPT (TO HOST) 0.1HF 10k 0.047HF 10k 1% 10k 1% - T D
C SMART-BATTERY CONNECTOR + SCL SDA BATT CS PGND DL LX DH BST DCIN VL MAX874 ...
pdfserv.maxim-ic.com/jp/an/AN676J.pdf

-48V Hot Swap Solution For Telecom Line Cards Assures Immunity To ... [Open results in new window]
... Following the start-up delay, the controller gradually turns Q1 ON, limiting the
inrush ... when power is restored after a brown out, or during battery swap when a ...
japan.maxim-ic.com/appnotes.cfm/an_pk/1881 - 35k

Parallel-Port Interface Powers Low Voltage Systems - マキシム [Open results in new window]
... the low-voltage logic required to increase battery life and ... When enabled, U1's
soft-start capability limits the inrush ... As a low-voltage SIM/Smart-Card level ...
japan.maxim-ic.com/appnotes.cfm/an_pk/1157 - 22k

MAX1917 Provides Pre-Bias Soft Start for Redundant Supply ... [Open results in new window]
... Abstract: Pre-bias soft start has become an important feature in redundant power
supply systems, parallel power supply modules, battery back-up voltage buses ...
japan.maxim-ic.com/appnotes.cfm/an_pk/3356 - 23k

Powering Six White LEDs with High Efficiency Using the MAX1848 ... [Open results in new window]
... Competing devices do not include soft-start or use less effective soft-start techniques,
causing significant voltage droop on the battery during start-up. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/1750 - 23k

Powering Four White LEDs with High Efficiency Using the MAX1848 ... [Open results in new window]
... Competing devices do not include soft-start or use less effective soft-start techniques,
causing significant voltage droop on the battery during start-up. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/1736 - 23k

Inductorless Voltage Converter Boosts a Single Lithium Cell ... [Open results in new window]
... battery discharges, the system compensates declining voltage with an increase in
efficiency, reaching 84% at 2.8V (Figure 2). Because the SIM and other smart ...
japan.maxim-ic.com/appnotes.cfm/an_pk/1791 - 20k

Trading Performance for Cost in Portable Power Supplies ... [Open results in new window]
... batteries are fresh and switches automatically to +3x when the battery voltage falls
below 2.5V. In a buck/boost application, another charge pump might start ...
japan.maxim-ic.com/appnotes.cfm/an_pk/269 - 31k

Power Conservation in 3V/5V Dual-Supply Systems - マキシム [Open results in new window]
... This behavior benefits battery-powered systems that run continuously; they start
up easily when the battery is fresh and continue to operate as the battery ...
japan.maxim-ic.com/appnotes.cfm/an_pk/662 - 32k

Simple Circuit Charges Lead-Acid Batteries - マキシム [Open results in new window]
... charge cycle ensures that all batteries charged at ... a charge cycle, press the Start
switch momentarily ... IC2 measures the battery-charging current by generating a ...
japan.maxim-ic.com/appnotes.cfm/an_pk/621 - 23k

Memory Products - Frequently Asked Questions - マキシム [Open results in new window]
... PowerCaps and other devices that have batteries but no freshness seal ... Can You
Water-wash Smart Sockets ... sealed and water baths will cause the battery to discharge ...
japan.maxim-ic.com/appnotes.cfm/an_pk/591 - 21k

Simple Circuit Disconnects Load - マキシム [Open results in new window]
... the disconnect completely isolates the battery from the load ... once started.mAny, however,
cannot start withmAximum load ... such as those from single-cell batteries. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/657 - 21k