[PDF] Circuit Enables PCs to Communicate via IrDA - AN631 [Open results in new window]
... To compress standard NRZ signals into valid IrDA (RZ) signals and to stretch standard
RZ IrDA
back to standard NRZ, IC1 must be driven by a clock frequency 16 ...
pdfserv.maxim-ic.com/en/an/AN631.pdf
[PDF] IrDA and RS-232: A Match Made in Silicon - AN3024 [Open results in new window]
... q PDA: Personal Digital Assistant q RS232: Recommended Standard 232 q RZ: Return
to Zero
Page 11. q SIR: Serial Infrared q SPI: Serial Peripheral Interface ...
pdfserv.maxim-ic.com/en/an/AN3024.pdf
IrDA and RS-232: A Match Made in Silicon - Maxim [Open results in new window]
... Digital Assistant; RS232: Recommended Standard 232; RZ: Return to Zero; SIR: Serial
Infrared;
SPI: Serial Peripheral Interface; TTL: Transistor ...
www.maxim-ic.com/appnotes.cfm/an_pk/3024 - 36k
DS26303 Short-Haul Line Interface Unit vs. IDT82V2048 - Maxim [Open results in new window]
... IDT82V2048 MCLK held high. The IDT82V2048 slices the incoming bipolar line signal
into RZ pulse (data-recovery
mode). IDT82V2048 MCLK held low. ...
www.maxim-ic.com/appnotes.cfm/an_pk/3916 - 38k
[PDF] DS26303 Short-Haul Line Interface Unit vs. IDT82V2048 - AN3916 [Open results in new window]
... IDT82V2048 MCLK held high. q The IDT82V2048 slices the incoming bipolar line signal
into RZ pulse (data-recovery
mode). IDT82V2048 MCLK held low. ...
pdfserv.maxim-ic.com/en/an/AN3916.pdf
[PDF] Spectral content of NRZ test patterns [Open results in new window]
Page 1. Spectral content of NRZ test patterns Non-return-to-zero (NRZ) signaling
is widely used for
data transmission in digital communication systems. ...
pdfserv.maxim-ic.com/en/an/AN3455.pdf
[PDF] FCC and ETSI Requirements for Short-Range UHF ASK-Modulated ... [Open results in new window]
... non-return-to-zero (NRZ) data sequence with data rate 1/T. The power spectrum of
this
square wave is shown in Figure 2, where the zero frequency is taken to be ...
pdfserv.maxim-ic.com/en/an/AN3587.pdf
[PDF] NRZ Applications - AN391 [Open results in new window]
... Keywords: Non-Return to Zero, NRZ, bipolar, NRZ applications, LIU, framer
Aug 30, 2002 APPLICATION NOTE
391 NRZ Applications Abstract ...
pdfserv.maxim-ic.com/en/an/AN391.pdf
HFTA-11.0: Spectral Content of NRZ Test Patterns - Maxim [Open results in new window]
... Test Patterns. Abstract: Non-return-to-zero (NRZ) signaling is widely used
for data transmission
in digital communication systems. ...
www.maxim-ic.com/appnotes.cfm/an_pk/3455 - 21k
[PDF] MAX3667: Driving A Laser Diode With the MAX3667 From A Single +3.3 ... [Open results in new window]
... SDH/SONET signals consist of non-return-to-zero data streams. Typical
expectations for
these systems are that they will maintain a 10 ...
pdfserv.maxim-ic.com/en/an/AN242.pdf
MAX3667: Driving A Laser Diode With the MAX3667 From A Single 3.3V ... [Open results in new window]
... has been added to the system. SDH/SONET signals consist of non-return-to-
zero data streams.
Typical expectations for these systems ...
www.maxim-ic.com/appnotes.cfm/an_pk/242 - 24k
[PDF] Circuit Tradeoffs Minimize Noise in Battery-Input Power Supplies ... [Open results in new window]
... Operating a buck converter in its deep continuous-conduction mode, in which the
inductor current does not return
to zero within each switching cycle, further ...
pdfserv.maxim-ic.com/en/an/AN653.pdf
Circuit Tradeoffs Minimize Noise in Battery-Input Power Supplies ... [Open results in new window]
... Operating a buck converter in its deep continuous-conduction mode, in which the
inductor current does not return
to zero within each switching cycle, further ...
www.maxim-ic.com/appnotes.cfm/an_pk/653 - 40k
[PDF] Frequency Undersampling in Coulomb-Counting: Measuring Current ... [Open results in new window]
... were no input offset or resolution errors and if the cell's charging efficiency
was 100%, one would expect
the value of the ACR to return to zero every time ...
pdfserv.maxim-ic.com/en/an/AN1798.pdf
Frequency Undersampling in Coulomb-Counting: Measuring Current ... [Open results in new window]
... were no input offset or resolution errors and if the cell's charging efficiency
was 100%, one would expect
the value of the ACR to return to zero every time ...
www.maxim-ic.com/appnotes.cfm/an_pk/1798 - 35k
