Search Results: Intermodulation

[PDF] Improving Receiver Intercept Point Using Selectivity - AN749 [Open results in new window]
... They allow us to predict the receiver's intermodulation (IM) performance, which
describes the radio's susceptibility to interference for adjacent or nearby ...
pdfserv.maxim-ic.com/en/an/AN749.pdf

Improving Receiver Intercept Point Using Selectivity - Maxim [Open results in new window]
... They allow us to predict the receiver's intermodulation (IM) performance, which
describes the radio's susceptibility to interference for adjacent or nearby ...
www.maxim-ic.com/appnotes.cfm/an_pk/749/ - 39k

Tuning the MAX2009/MAX2010 RF Predistorters for Optimal ... [Open results in new window]
... decreases the more the PA is backed off, linearization techniques are applied to
combine a maximum efficiency with a minimum of IM (intermodulation). ...
www.maxim-ic.com/appnotes.cfm/an_pk/4611 - 36k

[PDF] Tuning the MAX2009/MAX2010 RF Predistorters for Optimal ... [Open results in new window]
... decreases the more the PA is backed off, linearization techniques are applied to
combine a maximum efficiency with a minimum of IM (intermodulation). ...
pdfserv.maxim-ic.com/en/an/AN4611.pdf

Adjacent Channel Leakage Ratio (ACLR) Derivation for General RF ... [Open results in new window]
... or other device, is frequently dominated by the 3rd-order intermodulation distortion
(IM3 ... spacing from carrier 1. This generates the second "red" IM product to ...
www.maxim-ic.com/appnotes.cfm/an_pk/3902 - 24k

TD-SCDMA RD V2.1 Design Meets Rx-Blocking Mask and Sensitivity ... [Open results in new window]
... 2nd-Order Intermodulation Products (IM2). Figure 4. 2nd-order intermodulation
products. The 2nd-order intermodulation products due ...
www.maxim-ic.com/appnotes.cfm/an_pk/3961 - 31k

[PDF] TD-SCDMA RD V2.1 Design Meets Rx-Blocking Mask and Sensitivity ... [Open results in new window]
... Keywords: TD-SCDMA, 3GPP, Rx Mask, Sensitivity, MAX2392, MAX2507, block diagram,
blocking, cross-mod, cross- modulation, Intermodulation, reciprocal mixing ...
pdfserv.maxim-ic.com/en/an/AN3961.pdf

[PDF] Adjacent Channel Leakage Ratio (ACLR) Derivation for General RF ... [Open results in new window]
... or other device, is frequently dominated by the 3rd-order intermodulation distortion
(IM3 ... spacing from carrier 1. This generates the second "red" IM product to ...
pdfserv.maxim-ic.com/en/an/AN3902.pdf

[PDF] EJ53 current_WEB [Open results in new window]
... 15 Figure 2. Second-order intermodulation distortion occurs due to the two-tone
blocker in the ... LOW-FREQUENCY IM 2 PRODUCTS WANTED SIGNAL AT BASEBAND 0 f 1 -f 2 ...
pdfserv.maxim-ic.com/en/an/AN3380.pdf

[PDF] Audio Characterization Report for the DS1802 Dual Digital Audio ... [Open results in new window]
... between tap points, inter-channel matching or tracking between the two potentiometer
wipers, total harmonic distortion (THD), intermodulation distortion (IMD ...
pdfserv.maxim-ic.com/en/an/AN2119.pdf

[PDF] ADC and DAC Glossary - AN641 [Open results in new window]
... Page 7. INL for an ADC and a DAC. Intermodulation Distortion (IMD) ... The 2nd-
to 5th-order intermodulation products are as follows: ...
pdfserv.maxim-ic.com/en/an/AN641.pdf

[PDF] Critical DAC Parameters for Multi-Carrier GSM/EDGE Transmitters ... [Open results in new window]
... These are: Spurious-free Dynamic Range (SFDR), Signal-to-Noise Ratio (SNR),
Intermodulation Distortion (IMD), and Multi-tone power ratio (MTPR). ...
pdfserv.maxim-ic.com/en/an/AN1886.pdf

ADC and DAC Glossary - Maxim [Open results in new window]
... Intermodulation Distortion (IMD). ... The 2nd- to 5th-order intermodulation products
are as follows: 2nd-order intermodulation products (IM2): f1 + f2, f2 - f1; ...
www.maxim-ic.com/appnotes.cfm/an_pk/641/ - 38k

Mixer 2x2 Spurious Response and IP2 Relationship - Maxim [Open results in new window]
... For example, the 2nd-order intermodulation (IM) products will increase in
amplitude by 2dB when the input signal is raised by 1dB. ...
www.maxim-ic.com/appnotes.cfm/an_pk/1838 - 29k

Critical DAC Parameters for Multi-Carrier GSM/EDGE Transmitters ... [Open results in new window]
... 2. -12dBFS. -152dBFS/Hz. 4. -18dBFS. -158dBFS/Hz. 8. -24dBFS. -160dBFS/Hz.
Intermodulation Distortion (IMD), and Multi-tone power ratio (MTPR). ...
www.maxim-ic.com/appnotes.cfm/an_pk/1886 - 27k

[PDF] Triple/Dual/Single Mode CDMA LNA/Mixers Receiver System ... [Open results in new window]
... CDMA Receiver Sensitivity and Dynamic Range Before starting to specify the noise
figure and third intermodulation characteristics of a LNA and a mixer, we ...
pdfserv.maxim-ic.com/en/an/AN289.pdf

[PDF] Defining and Testing Dynamic Parameters in High-Speed ADCs, Part 1 ... [Open results in new window]
... q Two-tone intermodulation distortion (TTIMD) q Multi-tone intermodulation distortion
(MTIMD) ... Two-Tone Intermodulation Distortion (Two-Tone IMD) ...
pdfserv.maxim-ic.com/en/an/AN728.pdf

[PDF] Mixer 2x2 Spurious Response and IP2 Relationship - AN1838 [Open results in new window]
... For example, the 2nd-order intermodulation (IM) products will increase in
amplitude by 2dB when the input signal is raised by 1dB. ...
pdfserv.maxim-ic.com/en/an/AN1838.pdf

Triple/Dual/Single Mode CDMA LNA/Mixers Receiver System ... [Open results in new window]
... Before starting to specify the noise figure and third intermodulation characteristics
of a LNA and a mixer, we should understand narrow band CDMA and wide band ...
www.maxim-ic.com/appnotes.cfm/an_pk/289 - 66k