Search Results: Idle Mode™

Micro Tutorial 1: Understanding DC Electrical Characteristics of ... [Open results in new window]
... Supply Current Idle Mode at 25MHz, I IDLE, 15, 25, mA, 3. When idle mode is invoked
by software, internal clocks, serial ports, and timers will remain running. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1087 - 48k

Microcontrollers Improve Power Efficiency of 8051-Based Designs ... [Open results in new window]
... Idle Mode. Idle mode is the second clock management mode used in original 8051
architecture. ... Figure 7. Full/Idle/Power Management Mode Comparison. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1771 - 48k

NISTnet 소프트웨어 설치 및 TDMoP와 함께 사용 ... [Open results in new window]
... RX OOS[0 - ff] ... (7E) 5. Idle Code[0 - ff] ... (7E) 6. TX/RX Signal ... RX
OOS[0 - ff] ... (7E) 5. Idle Code[0 - ff] ... (7E) 6. TX/RX Signal ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3963 - 35k

DS2155 and DS26502 Software Comparison - Maxim [Open results in new window]
... 7F, PCICR, Per-Channel Idle Code Value Register. 80, TCICE1, Transmit Idle Code
Enable Register 1. 81, TCICE2, Transmit Idle Code Enable Register 2. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3360 - 73k

DS2155 and DS26401 Software Comparison - Maxim [Open results in new window]
... Per-Channel Transmit Idle Code, TIDR1 to TIDR24, Per-Channel Receive Idle Code,
RIDR1 to RIDR24, ... 80, TCICE1, 150, TCICE1, Transmit Idle Code Enable Register 1. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/403 - 77k

An Efficiency Primer for Switch-Mode, DC-DC Converter Power ... [Open results in new window]
... On the other hand, the pulse-skipping "idle mode" efficiency curves (A, B, and C
in Figure 8) maintain efficiency even down to very light loads since switching ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4266 - 58k

Initialization Steps for the DS31256 - Maxim [Open results in new window]
... All the physical ports (ports 0 to 15) send all ones (not HDLC idle code),
therefore placing the DS31256 in an idle upon power-up. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/2867 - 25k

Using the High-Speed Micro's Watchdog Timer - Maxim [Open results in new window]
... to be seen. DJNZ R1, LOOP ; MOV P1, #00 ; P1 = 0, Reset causes P1 = 1 ;
MOV PCON, #01h ; Go to idle mode waiting for reset SJMP ...
korea.maxim-ic.com/appnotes.cfm/an_pk/548 - 39k

Triple/Dual/Single Mode CDMA LNA/Mixers Receiver System ... [Open results in new window]
... Operating supply current, High-gain low-linearity idle mode. 21. 24. mA. ... Operating
supply current, High-gain low-linearity idle mode. 19. 21.5. mA. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/289 - 67k

WiBro Reference Design with the MAX2837 - Maxim [Open results in new window]
... active, 1.8, mA. Idle Supply Current, MAX2837 in idle mode; PA in shutdown;
regulators and VCTCXO active, 34.8, mA. Transmit Supply Current, ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4274 - 28k

Portable Temperature Monitoring Demystified - Maxim [Open results in new window]
... and the E² memory is specified for both idle mode and full ... The code was written as
a series of subroutines ... To conserve power, the processor idles with only its ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1754 - 41k

Choosing the Right DC-DC Converter for Automotive Applications ... [Open results in new window]
... Low quiescent current: < 300µA, Prevents battery drain from standby systems when
car ignition is off, Idle Mode™operation for high-efficiency at light loads. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1845 - 38k

Using the DS5250 as a Drop-In Upgrade for the DS5002 - Maxim [Open results in new window]
... For clock control and power management, the DS5250 provides many features beyond
the standard stop and idle modes supported by the DS5002FP. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/2034 - 38k

Instant Performance Enhancement with Flash Microcontrollers ... [Open results in new window]
... application programmable Flash; 1K byte SRAM for MOVX; Power Management Modes:
Idle Mode, Stop Mode, Divide-by-1024 Mode; Two serial ports; ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3452 - 30k

Interfacing SPI Real-Time Clocks (RTCs) with a Microcontroller ... [Open results in new window]
... mode 1,0, and mode 1,1. The SPI master must use a mode supported by ... The RTC
automatically determines the polarity by detecting the idle state of SCLK when CE ...
korea.maxim-ic.com/appnotes.cfm/an_pk/502 - 23k

Replacing an Atmel TS80C51U2 with a DS80C320/323 Microcontroller ... [Open results in new window]
... 256 Bytes Internal RAM, Y, Y. Dual Data Pointer, DPTR0, DPTR1, Y, Y. Power Saving
Modes, Idle mode, sleep, Y, Y. Power-Fail Reset, Brownout detector, Y, N. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/610 - 40k

Using Power Management with High-Speed Microcontrollers - Maxim [Open results in new window]
... Idle Mode. The Idle mode halts operation of the microcontroller processor core
but leaves internal clocks, serial ports, and timers running. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/78 - 92k

DS2155 To DS21458 Migration - Maxim [Open results in new window]
... CCR1.3, 70h, DICAI, X, --, Disable Idle Code Auto Increment - Selects/deselects
the auto-increment feature for the transmit and receive idle code array address ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3357 - 25k

DS2155 vs. DS21x5y: Software and Hardware Considerations - Maxim [Open results in new window]
... The DS2155 contains a 64-byte Idle Code Array accessed by the Idle Array Address
Register (IAAR) and the Per-Channel Idle Code Register (PCICR). ...
korea.maxim-ic.com/appnotes.cfm/an_pk/374 - 101k