Search Results: Idle Mode™

Micro Tutorial 1: Understanding DC Electrical Characteristics of ... [Open results in new window]
... Supply Current Idle Mode at 25MHz, I IDLE, 15, 25, mA, 3. When idle mode is invoked
by software, internal clocks, serial ports, and timers will remain running. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/1087 - 48k

DS2155 and DS26502 Software Comparison - マキシム [Open results in new window]
... 7F, PCICR, Per-Channel Idle Code Value Register. 80, TCICE1, Transmit Idle Code
Enable Register 1. 81, TCICE2, Transmit Idle Code Enable Register 2. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/3360 - 74k

NISTnet ... [Open results in new window]
... RX OOS[0 - ff] ... (7E) 5. Idle Code[0 - ff] ... (7E) 6. TX/RX Signal ... RX
OOS[0 - ff] ... (7E) 5. Idle Code[0 - ff] ... (7E) 6. TX/RX Signal ...
japan.maxim-ic.com/appnotes.cfm/an_pk/3963 - 38k

Initialization Steps for the DS31256 - マキシム [Open results in new window]
... All the physical ports (ports 0 to 15) send all ones (not HDLC idle code),
therefore placing the DS31256 in an idle upon power-up. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/2867 - 25k

Triple/Dual/Single Mode CDMA LNA/Mixers Receiver System ... [Open results in new window]
... Operating supply current, High-gain low-linearity idle mode. 21. 24. mA. ... Operating
supply current, High-gain low-linearity idle mode. 19. 21.5. mA. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/289 - 67k

WiBro Reference Design with the MAX2837 - マキシム [Open results in new window]
... active, 1.8, mA. Idle Supply Current, MAX2837 in idle mode; PA in shutdown;
regulators and VCTCXO active, 34.8, mA. Transmit Supply Current, ...
japan.maxim-ic.com/appnotes.cfm/an_pk/4274/ - 29k

Portable Temperature Monitoring Demystified - マキシム [Open results in new window]
... and the E² memory is specified for both idle mode and full ... The code was written as
a series of subroutines ... To conserve power, the processor idles with only its ...
japan.maxim-ic.com/appnotes.cfm/an_pk/1754 - 42k

Choosing the Right DC-DC Converter for Automotive Applications ... [Open results in new window]
... Low quiescent current: < 300µA, Prevents battery drain from standby systems when
car ignition is off, Idle Mode™operation for high-efficiency at light loads. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/1845 - 39k

Instant Performance Enhancement with Flash Microcontrollers ... [Open results in new window]
... application programmable Flash; 1K byte SRAM for MOVX; Power Management Modes:
Idle Mode, Stop Mode, Divide-by-1024 Mode; Two serial ports; ...
japan.maxim-ic.com/appnotes.cfm/an_pk/3452 - 30k

Interfacing SPI Real-Time Clocks (RTCs) with a Microcontroller ... [Open results in new window]
... mode 1,0, and mode 1,1. The SPI master must use a mode supported by ... The RTC
automatically determines the polarity by detecting the idle state of SCLK when CE ...
japan.maxim-ic.com/appnotes.cfm/an_pk/502 - 24k

マイクロコントローラにより、8051 ... [Open results in new window]
This application note looks at ways to reduce power consumption by choosing efficient
clock source and clock speed, the use of stop mode, idle mode and burst mode ...
japan.maxim-ic.com/appnotes.cfm/an_pk/1771 - 21k

Replacing an Atmel TS80C51U2 with a DS80C320/323 Microcontroller ... [Open results in new window]
... 256 Bytes Internal RAM, Y, Y. Dual Data Pointer, DPTR0, DPTR1, Y, Y. Power Saving
Modes, Idle mode, sleep, Y, Y. Power-Fail Reset, Brownout detector, Y, N. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/610 - 40k

Using Power Management with High-Speed Microcontrollers ... [Open results in new window]
... Idle Mode. The Idle mode halts operation of the microcontroller processor core
but leaves internal clocks, serial ports, and timers running. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/78 - 93k

DS2155 To DS21458 Migration - マキシム [Open results in new window]
... CCR1.3, 70h, DICAI, X, --, Disable Idle Code Auto Increment - Selects/deselects
the auto-increment feature for the transmit and receive idle code array address ...
japan.maxim-ic.com/appnotes.cfm/an_pk/3357 - 26k

DS2155 vs. DS21x5y: Software and Hardware Considerations ... [Open results in new window]
... The DS2155 contains a 64-byte Idle Code Array accessed by the Idle Array Address
Register (IAAR) and the Per-Channel Idle Code Register (PCICR). ...
japan.maxim-ic.com/appnotes.cfm/an_pk/374 - 101k

How to Configure the DS89C430 Dual Serial Ports with Different ... [Open results in new window]
... IDLE (Bit 0) Idle Mode Select: Setting this bit stops program execution but leaves
the CPU oscillator, timers, serial ports, and interrupts active. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/4351 - 70k

DS2152L vs. DS2151Q - マキシム [Open results in new window]
... TIR1-TIR3, Transmit Idle Registers 1-3. Per Channel Code (Idle) Insertion (Section
8.0) Register, Description. TCC1-TCC3, Transmit Channel Control 1-3. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/349 - 35k

[PDF] マイクロコントローラにより、8051を ... [Open results in new window]
... FULL/IDLE/POWER MANAGEMENT MODE COMPARISON FREQUENCY (MHz) I CC (mA) ... CONVENTIONAL
8051 RESUME OPERATION CRYSTAL WARMUP IDLE MODE STOP MODE RE-ENTER STOP MODE ...
pdfserv.maxim-ic.com/jp/an/AD0103J.pdf