Search Results: Half-Duplex

シリアルのディジタルデータネットワーク ... [Open results in new window]
... Transmission, LS bit first, half-duplex, MS bit first plus Acknowledge bit,
half-duplex, MS bit first plus Acknowledge bit, half-duplex, MS bit first, full- ...
japan.maxim-ic.com/appnotes.cfm/an_pk/3438 - 31k

RS-485 (EIA/TIA-485) Differential Data Transmission System Basics ... [Open results in new window]
... キーワード: RS-485, RS485, RS-422, RS422, EIA/TIA-485, EIA/TIA-422, differential
data transmission, full-duplex, half-duplex, unit load, fractional unit ...
japan.maxim-ic.com/appnotes.cfm/an_pk/736 - 28k

Using RS-485/RS-422 Transceivers in Fieldbus Networks ... [Open results in new window]
... PROFIBUS DP connects to the bus using half-duplex RS-485 transceivers, which
transfer data over a single, shielded, twisted-pair cable. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/1833 - 35k

Using the MAX3157 High-CMR RS-485 Transceivers - マキシム [Open results in new window]
... For half-duplex two-wire RS-485 transmission, the internal receiver switch is set
as shown; and a single 2-wire line is connected to terminals Y and Z ...
japan.maxim-ic.com/appnotes.cfm/an_pk/1137 - 44k

Fundamentals of RS-232 Serial Communications - マキシム [Open results in new window]
... In half-duplex systems, this condition maintains the DCE in receive mode and disables
transmit mode. ... Figure 5. Half-duplex communication scheme. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/83 - 46k

Methods for Trimming the Power Required in RS-485 Systems ... [Open results in new window]
... That is, if the differential voltage on the RS-485 side of a half-duplex configuration
is 0V, and no master transceiver is driving the line (or a connection ...
japan.maxim-ic.com/appnotes.cfm/an_pk/1090 - 40k

Ultra High Speed Microcontroller Hardware Enhances Serial Port ... [Open results in new window]
... operation. Mode 0 allows half-duplex synchronous communication of 8-bit
data using a baud clock derived from the system clock. Mode ...
japan.maxim-ic.com/appnotes.cfm/an_pk/600 - 57k

Reading and Writing 1-Wire® Devices Through Serial Interfaces ... [Open results in new window]
... General Information. 1-Wire is the only voltage-based digital system that works
with two contacts, data and ground, for half-duplex bidirectional communication. ...
japan.maxim-ic.com/appnotes.cfm/an_pk/74 - 61k

複数の周辺機器を制御するSPI/I²Cバスライン ... [Open results in new window]
... 2.Multiple devices share the same bus 3.Received data is acknowledged, 1.Speed:
SMBus limited to 100kHz; I²C limited to 3.4MHz 2.Half-duplex operation 3.Open ...
japan.maxim-ic.com/appnotes.cfm/an_pk/4024 - 52k

DS31256 PCI Bus Utilization - マキシム [Open results in new window]
... Total PCI Latency, 1,376,142.86, No. of Bus cycles required/sec, 15,693,122, Half
Duplex, Full Duplex. Bus utilization, 47.6%, 95.11%. Bus Capacity (Mbps), 264, ...
japan.maxim-ic.com/appnotes.cfm/an_pk/3475 - 33k

Selecting and Using RS-232, RS-422, and RS-485 Serial Data ... [Open results in new window]
... more. In a half-duplex RS-485 network, the master transceiver tri-states
the bus after transmitting a message to the slaves. Then ...
japan.maxim-ic.com/appnotes.cfm/an_pk/723/ - 39k