Search Results: Half-Duplex

[PDF] Explanation of Maxim RS-485 Features - AN367 [Open results in new window]
... rs485, transceivers, EIA/TIA-485, RS-422, rs422, EIA/TIA-422, 12Mbps, 2.5V supply,
unit- load, ESD protection, protected, +/-15kV ESD, half-duplex, full-duplex ...
pdfserv.maxim-ic.com/en/an/AN367.pdf

Serial Digital Data Networks - Maxim [Open results in new window]
... Transmission, LS bit first, half-duplex, MS bit first plus Acknowledge bit,
half-duplex, MS bit first plus Acknowledge bit, half-duplex, MS bit first, full- ...
www.maxim-ic.com/appnotes.cfm/an_pk/3438/ - 29k

[PDF] Serial Digital Data Networks - AN3438 [Open results in new window]
... Transmission LS bit first, half-duplex MS bit first plus Acknowledge bit,
half- duplex MS bit first plus Acknowledge bit, half- duplex ...
pdfserv.maxim-ic.com/en/an/AN3438.pdf

Using the MAX3157 High-CMR RS-485 Transceivers - Maxim [Open results in new window]
... For half-duplex two-wire RS-485 transmission, the internal receiver switch is set
as shown; and a single 2-wire line is connected to terminals Y and Z ...
www.maxim-ic.com/appnotes.cfm/appnote_number/1137 - 49k

RS-485 (EIA/TIA-485) Differential Data Transmission System Basics ... [Open results in new window]
... Keywords: RS-485, RS485, RS-422, RS422, EIA/TIA-485, EIA/TIA-422, differential data
transmission, full-duplex, half-duplex, unit load, fractional unit load, EMI ...
www.maxim-ic.com/appnotes.cfm/an_pk/736/ - 26k

Explanation of Maxim RS-485 Features - Maxim [Open results in new window]
... Full/Half Duplex. ... This is referred to as "half duplex." A full-duplex system, on
the other hand, would allow communications in both directions simultaneously. ...
www.maxim-ic.com/appnotes.cfm/an_pk/367 - 41k

[PDF] Using RS-485/RS-422 Transceivers in Fieldbus Networks - AN1833 [Open results in new window]
... PROFIBUS DP connects to the bus using half-duplex RS-485 transceivers, which
transfer data over a single, shielded, twisted-pair cable. ...
pdfserv.maxim-ic.com/en/an/AN1833.pdf

Using RS-485/RS-422 Transceivers in Fieldbus Networks - Maxim [Open results in new window]
... PROFIBUS DP connects to the bus using half-duplex RS-485 transceivers, which
transfer data over a single, shielded, twisted-pair cable. ...
www.maxim-ic.com/appnotes.cfm/an_pk/1833 - 33k

[PDF] RS-485 (EIA/TIA-485) Differential Data Transmission System Basics ... [Open results in new window]
... Keywords: RS-485, RS485, RS-422, RS422, EIA/TIA-485, EIA/TIA-422, differential data
transmission, full- duplex, half-duplex, unit load, fractional unit load ...
pdfserv.maxim-ic.com/en/an/AN736.pdf

RS-485 Data Interface Gives Isolated, Full-Duplex Operation ... [Open results in new window]
... meters. IC2 is a complete half-duplex interface that includes transceivers,
optocouplers, a power driver, and a transformer. The ...
www.maxim-ic.com/appnotes.cfm/an_pk/2116 - 23k

[PDF] Visio-MAX3420E Info Card_revD.vsd [Open results in new window]
... The FDUPSPI bit configures the SPI interface for full-duplex or half-duplex operation.
In half-duplex mode (FDUPSPI = 0) the MISO pin can be left unconnected. ...
pdfserv.maxim-ic.com/en/an/AN3592.pdf

[PDF] RS-485 Data Interface Gives Isolated, Full-Duplex Operation ... [Open results in new window]
... meters. IC2 is a complete half-duplex interface that includes transceivers,
optocouplers, a power driver, and a transformer. The ...
pdfserv.maxim-ic.com/en/an/AN2116.pdf

[PDF] SPI/I²C Bus Lines Control Multiple Peripherals [Open results in new window]
... Because 2-wire interfaces have only one data line, they can operate in half-duplex
mode only (data can only be transmitted or received on a given cycle, but ...
pdfserv.maxim-ic.com/en/an/AN4024.pdf

SPI/I²C Bus Lines Control Multiple Peripherals - Maxim [Open results in new window]
... Because 2-wire interfaces have only one data line, they can operate in half-duplex
mode only (data can only be transmitted or received on a given cycle, but ...
www.maxim-ic.com/appnotes.cfm/an_pk/4024 - 42k

[PDF] Fundamentals of RS-232 Serial Communications - AN83 [Open results in new window]
... In half-duplex systems, this condition maintains the DCE in receive mode and disables
transmit mode. ... Page 10. Figure 5. Half-duplex communication scheme. ...
pdfserv.maxim-ic.com/en/an/AN83.pdf

[PDF] Using the MAX3157 High-CMR RS-485 Transceivers - AN1137 [Open results in new window]
... For half-duplex two-wire RS-485 transmission, the internal receiver switch is set
as shown; and a single 2-wire line is connected to terminals Y and Z ...
pdfserv.maxim-ic.com/en/an/AN1137.pdf