Search Results: ECL

LVDS Splitter Simplifies High-Speed Signal Distribution - Maxim [Open results in new window]
A discussion of some of the benefits of the low voltage differential signaling
(LVDS) standard compared to the more traditional ECL, PECL and CML standards for ...
korea.maxim-ic.com/appnotes.cfm/an_pk/872/ - 27k

Applying HSTL Signals to PECL Input Devices - Maxim [Open results in new window]
... PECL (positive supply referred ECL) is an older standard than HSTL and was developed
as a higher speed alternative to the TTL logic standards. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1752 - 36k

Novel Storage Idea Supports Ultra-Fast Data Acquisition - Maxim [Open results in new window]
... 핵심 단어: data acquisition system, analog to digital converter, ADC, flash,
time-interleaved quantizer, ECL-to-TTL level shifters, ECL termination, FR4 ...
korea.maxim-ic.com/appnotes.cfm/an_pk/948 - 35k

Advantages of AC-Coupling in SerDes Applications - Maxim [Open results in new window]
... 핵심 단어: AC-coupling, AC coupling, LVDS, ECL, level shifting, common-mode voltage,
SERDES, serializer, deserializer, ATT, maximum total attenuation ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4085 - 25k

ADC Captures 1Gsps - Maxim [Open results in new window]
... This termination may be connected anywhere between ground and -2V for compatibility
with standard emitter-coupled-logic (ECL) drive levels. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/642 - 35k

An Introduction to Jitter in Communications Systems - Maxim [Open results in new window]
... 시트 (PDF, 196kB), MAX9360, LVTTL/TTL/CMOS-차동 LVECL/ECL 변환기,
전체 데이터 시트 (PDF, 100kB), MAX9374, 차동 LVPECL ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1916 - 40k

Charge Pump Converts -5V to +5V - Maxim [Open results in new window]
... A good example is emitter-coupled logic (ECL), which requires a main supply voltage
of -5.2V. For those systems that require a positive supply as well (to ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3534 - 19k

Synchronizing Multiple High-Speed Multiplexed DACs for Transmit ... [Open results in new window]
... If a square wave (eg, ECL) clock is used for the DAC, synchronization between two
DACs can be achieved by using the simple high-speed logic circuit shown in ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3901 - 29k

The MAX555 PLCC-to-TQFP Printed Circuit Board (PCB) Layout ... [Open results in new window]
... left side of the package. All 50Ω ECL termination resistors are located
adjacent to the input pins. The remaining two sides of ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1120 - 24k

Comparator/DAC Combinations Solve Data-Acquisition Problems ... [Open results in new window]
... 8-bit DAC/comparator ICs from Maxim include the quad MAX516 (a), the high-speed,
TTL-compatible MAX910 (b), and the ECL-compatible MAX911 (not shown). ...
korea.maxim-ic.com/appnotes.cfm/an_pk/647 - 40k

Phase-Lock Loop Applications Using the MAX9382 - Maxim [Open results in new window]
... F 0 = operating frequency. 관련 부품, APP 1130: Jun 26, 2002. MAX9382, ECL/PECL
위상 주파수 탐지기, 전체 데이터 시트 (PDF, 224kB), 무료 샘플. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1130 - 29k

Tech Brief 37: Replacing Passive Hybrid Delay Lines with All ... [Open results in new window]
... exists. In other applications, passive delays are used in digital fashion
but with reduced voltage levels (eg, ECL). Replacement ...
korea.maxim-ic.com/appnotes.cfm/an_pk/983 - 22k

Negative Buck Regulator Employs Step-Up Controller - Maxim [Open results in new window]
... Figure 1. With an external op amp to invert its voltage feedback, this boost-mode
dc-dc controller derives a regulated -3V from the -5.2V ECL supply. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/933 - 19k

Murphy's Law and the Risks of Designing "Off Data Sheet" - Maxim [Open results in new window]
... million pieces this year". As for new products, a standard logic family
once used emitter-coupled logic (ECL). It was faster than ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4429/ - 47k

Interfacing High-Speed Signals - Maxim [Open results in new window]
... 50Ω, τ = 2.5ns). A real-life example of a case with specifications close
to these is a low-impedance buffer driving an ECL input. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4168 - 32k

High-Speed Signal Distribution Using Low-Voltage Differential ... [Open results in new window]
... It also typically consumes less power than other signaling systems such as ECL and
CML; however, the amount of power consumed often depends on the termination ...
korea.maxim-ic.com/appnotes.cfm/an_pk/873 - 31k

Selecting the Right Comparator - Maxim [Open results in new window]
... For ultra-high-speed ECL and PECL outputs with 500ps propagation delay, refer
to the MAX9600/MAX9601/MAX9602 part families. Comments ...
korea.maxim-ic.com/appnotes.cfm/an_pk/886/ - 41k