Search Results: Contact Bounce

Circuit Removes Relay-Contact Bounce - Maxim [Open results in new window]
... controller. An example of relay-contact bounce (Figure 2) shows three bounces
with an inrush current peak of almost 30A. (The top ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3743 - 20k

Protecting Against Momentary Power Loss Due to Battery-Bounce ... [Open results in new window]
... Against Momentary Power Loss Due to Battery-Bounce. ... can cause momentary interruptions
when batteries lose contact. ... the impact can open internal contacts for as ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3209 - 23k

Interfacing Switches and Relays to the Real World in Real Time ... [Open results in new window]
... 핵심 단어: switch debouncers, 15kV, ESD, switch ... Contact bounce is not acceptable,
because automotive- and ... the application note, "Switch Bounce and Other ...
korea.maxim-ic.com/appnotes.cfm/an_pk/764/ - 51k

Switch Bounce and Other Dirty Little Secrets - Maxim [Open results in new window]
... rising-edge switch bounce (for a 5A contact relay) shows an ... This article highlights
the application of IC switch debouncers, while describing the ... Switch Bounce. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/287 - 36k

Surge Testing Solid-State USB Switches and Other Overcurrent ... [Open results in new window]
... 핵심 단어: USB, universal serial bus, power-supply sequencing, mechanical relay,
contact bounce, hot-swap controller, hot swap, power-supply sequencer ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4226 - 28k

Software Methods to Achieve Robust 1-Wire® Communication in ... [Open results in new window]
... Figure 1. Contact bounce averaged from 100 contacts using a shorted iButton. Figure
2. Contact bounce of a single iButton arriving at the probe. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/159 - 64k

Semiconductor Toggle Switch - Maxim [Open results in new window]
... Power is delivered by circuitry rather than a pair of contacts that go straight
to the battery. Protection can be provided against contact bounce and power ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3223 - 22k

-48V Hot Swap Solution For Telecom Line Cards Assures Immunity To ... [Open results in new window]
... the controller holds power switch Q1 in the OFF state for 300ms, allowing time for
the card to be firmly in place and connector-contact bounce to settle before ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1881 - 34k

Manually Operated Digital Potentiometer Doesn't Need a ... [Open results in new window]
... microcontroller. To mask the effect of contact bounce in mechanical switches
S1 and S2, a dual switch debouncer (IC1) is used. A ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1118 - 21k

Switching Between Battery and External Power Sources - Maxim [Open results in new window]
... First, contact bounce effects can occur when the external source is connected and
disconnected, resulting in power spikes, as shown in Figure 2. Second, the ...
korea.maxim-ic.com/appnotes.cfm/an_pk/1136 - 23k

Where Is Ground? - Maxim [Open results in new window]
... In simple terms, as the switch starts opening on the +25V side, the contact
will bounce between open circuit and being connected to +25V. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4292/ - 32k

Interfacing SD Cards with the TINI System - Maxim [Open results in new window]
... Error detection allows for robust error recovery in the event of physically induced
errors such as contact bounce during insertion and removal or nonideal ...
korea.maxim-ic.com/appnotes.cfm/an_pk/4068 - 35k

Minimizing Short-Circuit Current Amplitude and Pulse Width When ... [Open results in new window]
... closures. High-current relay contacts also produce bouncing contact closure
and exhibit variable contact resistance during closure. ...
korea.maxim-ic.com/appnotes.cfm/an_pk/2694 - 33k

SD Media Format Expands the MAXQ2000's Space for Nonvolatile Data ... [Open results in new window]
... Error detection allows for robust error recovery in the event of physically induced
errors such as contact bounce during insertion and removal or nonideal ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3969 - 35k

Designing Robust and Fault-Tolerant Motion-Control Feedback ... [Open results in new window]
... or wires sever due to machine vibration, the open or short fault often exhibits
several open/reconnect or short/open cycles similar to the contact bounce in a ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3161 - 39k

Security System Control with the MAXQ2000 - Maxim [Open results in new window]
... Additionally, to prevent a switch's bouncing contacts from registering multiple
presses, a key must be held down for a certain ... CONTACT US: SEND US AN EMAIL. ...
korea.maxim-ic.com/appnotes.cfm/appnote_number/3546 - 42k

Pushbuttons Control Regulated Switching Converter - Maxim [Open results in new window]
... A time-delay network (R1, R2, and C1) masks the switch bounce on S1 that would ... pin
to ramp slowly to 0V, thereby removing the effect of any bounce that occurs ...
korea.maxim-ic.com/appnotes.cfm/an_pk/3535 - 21k