Enter keywords or part number    



 
  All pages     Appnotes     Company     Products     Support  


[PDF] Transmitter Reference Design for a 900MHz Full-Duplex Radio ...   [Open results in new window]
... and I CC = 190mA, while meeting 14dB of CNR (1.22Mbps BPSK) at 10:1 VSWR (all angles). ...
PP 1.0Mbps PN bit stream (unfiltered) applied to BPSK input, unless ...

pdfserv.maxim-ic.com/en/an/AN4171.pdf

Manchester Data Encoding for Radio Communications - Maxim   [Open results in new window]
... Manchester encoding is a form of binary phase-shift keying (BPSK) that has gained
wide acceptance as the modulation scheme for low-cost radio-frequency (RF ...

www.maxim-ic.com/appnotes.cfm/an_pk/3435 - 27k

Transmitter Reference Design for a 900MHz Full-Duplex Radio ...   [Open results in new window]
... of delivering more than +19dBm with V CC = 2.9V and I CC = 170mA, and +20dBm with
V CC = 3.3V and I CC = 190mA, while meeting 14dB of CNR (1.22Mbps BPSK) at 10 ...

www.maxim-ic.com/appnotes.cfm/an_pk/4171/ - 29k

Transmitter Reference Design for a 900MHz Full-Duplex Radio ...   [Open results in new window]
... of delivering more than +19dBm with V CC = 2.9V and I CC = 170mA, and +20dBm with
V CC = 3.3V and I CC = 190mA, while meeting 14dB of CNR (1.22Mbps BPSK) at 10 ...

www.maxim-ic.com/appnotes.cfm/an_pk/4171 - 29k

[PDF] Manchester Data Encoding for Radio Communications - AN3435   [Open results in new window]
... Manchester encoding is a form of binary phase-shift keying (BPSK) that has gained
wide acceptance as the modulation scheme for low-cost radio-frequency (RF ...

pdfserv.maxim-ic.com/en/an/AN3435.pdf

Universal GPS Receiver Lets You Use a Laptop PC for Soft Baseband ...   [Open results in new window]
... The baseband signal is modulated with binary phase-shift keying (BPSK), and upconverted
to the L1 band for transmission. Analysis of Signal-Acquisition Methods. ...

www.maxim-ic.com/appnotes.cfm/an_pk/4237 - 38k

[PDF] Universal GPS Receiver Lets You Use a Laptop PC for Soft Baseband ...   [Open results in new window]
... The baseband signal is modulated with binary phase-shift keying (BPSK), and upconverted
to the L1 band for transmission. Analysis of Signal-Acquisition Methods ...

pdfserv.maxim-ic.com/en/an/AN4237.pdf

[PDF] An Introduction to Spread-Spectrum Communications - AN1890   [Open results in new window]
... frequency bandwidth. Spread-spectrum modulation is applied on top of a
conventional modulation such as BPSK or direct conversion. One ...

pdfserv.maxim-ic.com/en/an/AN1890.pdf

An Introduction to Spread-Spectrum Communications - Maxim   [Open results in new window]
... frequency bandwidth. Spread-spectrum modulation is applied on top of a
conventional modulation such as BPSK or direct conversion. One ...

www.maxim-ic.com/appnotes.cfm/an_pk/1890/ - 39k

An Introduction to Spread-Spectrum Communications - Maxim   [Open results in new window]
... frequency bandwidth. Spread-spectrum modulation is applied on top of a
conventional modulation such as BPSK or direct conversion. One ...

www.maxim-ic.com/appnotes.cfm/an_pk/1890 - 39k

[PDF] Designing a Low-Cost, Low-Component-Count GPS Receiver - AN3952   [Open results in new window]
... 5 , the corresponding post correlator E b /N 0 for the BPSK modulation used is
no less than 9.5dB (AWGN dominated) [3]. E b /N 0 is defined as ...

pdfserv.maxim-ic.com/en/an/AN3952.pdf

Designing a Low-Cost, Low-Component-Count GPS Receiver - Maxim   [Open results in new window]
... Assuming the baseband processor requires a BER of 10 -5 , the corresponding post
correlator E b /N 0 for the BPSK modulation used is no less than 9.5dB (AWGN ...

www.maxim-ic.com/appnotes.cfm/an_pk/3952 - 24k



        •         •         •     Privacy Policy     •     Legal Notices

    Copyright © 2009 by Maxim Integrated Products