The 4 x 4 and 4 x 3 MCMs offer a high-density packaging arrangement for the DS21Q44 E1 enhanced quad framer. Either three (DS21FT44) or four (DS21FF44) silicon die of these devices is packaged in a multichip module (MCM) with the electrical connections as shown in Figure 1-1.
All of the functions available on the DS21Q44 are also available in the MCM packaged version. However, in order to minimize package size, some signals have been deleted or combined. These differences are detailed in Table 1-1. In the 4 x 3 (FT) version, the fourth quad framer is not populated and thus all the signals to and from this fourth framer are absent and should be treated as no connects (NC). Table 2-1 lists all of the signals on the MCM and it also lists the absent signals for the 4 x 3.
The availability of both a 12-channel and a 16-channel version allow the maximum framer density with the lowest cost.
Key Features
16 or 12 completely independent E1 framers in one small 27mm x 27mm package
Each multichip module (MCM) contains either four (FF) or three (FT) DS21Q44 die
Each quad framer can be concatenated into a single 8.192MHz backplane data stream
IEEE 1149.1 JTAG-Boundary Scan Architecture
DS21FF44 and DS21FT44 are pin compatible with DS21FF42 and DS21FT42, respectively, to allow the same footprint to support T1 and E1 applications
300-pin MCM BGA 1.27mm pitch package (27mm x 27mm)
Low-power 3.3V CMOS with 5V tolerant input and outputs
Notes: **This pricing is BUDGETARY, for comparing similar parts. Prices are in
U.S. dollars and subject to change. Quantity pricing may vary
substantially and international prices may differ due to local
duties, taxes, fees, and exchange rates. For volume-specific prices
and delivery, please see the price and availability page
or contact an authorized distributor.
Download
E-Mail