Dual, Low-Power, 1200Mbps ATE Driver/Comparator with 35mA Load

Limited Availability

The MAX9975 dual, low-power, high-speed, pin electronics driver/comparator with 35mA load IC includes, for each channel, a three-level pin driver, a dual comparator, variable clamps, and an active load. An additional differential comparator allows comparisons between the two channels. The driver features a wide voltage range and high-speed operation, includes high-impedance and active-termination (3rd-level drive) modes, and is highly linear even at low voltage swings. The dual comparator provides low dispersion (timing variation) over a wide variety of input conditions, and differential outputs. The clamps provide damping of high-speed device-under-test (DUT) waveforms when the device is configured as a high impedance receiver. The programmable load supplies up to 35mA of source and sink current. The load facilitates contact/continuity testing, at-speed parametric testing of I_OH and I_OL, and pullup of high-output-impedance devices.

The MAX9975 provides high-speed, differential control inputs and open-collector outputs with internal 50Ω termination resistors that make it CML compatible. These features significantly reduce the discrete component count on the circuit board.

A 3-wire, low-voltage, CMOS-compatible serial interface programs the low-leakage and tri-state/terminate operational configurations of the MAX9975.

The MAX9975ARCCQ operating range is -1.5V to +6.5V. The MAX9975AZCCQ operating range is -1.0V to +7.0V. The MAX9975 features power dissipation of only 1.6W per channel. The device is available in a 100-pin, 14mm x 14mm x 0.1mm body, and 0.5mm pitch TQFP. An exposed 8mm x 8mm die pad on the top of the package facilitates efficient heat removal. The device is specified to operate with an internal die temperature of +60°C to +100°C, and features a die temperature monitor output.

Download Rev 0 (PDF, 888kB) E-Mail