Maxim > Products > T/E Carrier and Packetized Communications > DS3171, DS3172, DS3173, DS3174

DS3171, DS3172, DS3173, DS3174

Single/Dual/Triple/Quad DS3/E3 Single-Chip Transceivers

 Overview   Technical Documents   Ordering Info   Related Products   User Comments (0)   All   


Status Explanations for product status codes

Active: In Production.

Description

The DS3171 (single), DS3172 (dual), DS3173 (triple), and DS3174 (quad) perform framing, formatting, and line transmission and reception. These devices contain integrated LIU(s), framer/formatter for M23 DS3, C-bit DS3, G.751 E3, G.832 E3, or a combination of the above signal formats.

Each LIU has independent receive and transmit paths. The receiver LIU block performs clock and data recovery from a B3ZS- or HDB3-coded AMI signal and monitors for loss of the incoming signal, or can be bypassed for direct clock and data inputs. The receiver LIU block optionally performs B3ZS/HDB3 decoding. The transmitter LIU drives standard pulse-shape waveforms onto 75Ω coaxial cable or can be bypassed for direct clock and data outputs. The jitter attenuator can be placed in either transmit or receive data path when the LIU is enabled. The DS3/E3 framers transmit and receive serial data in properly formatted M23 DS3, C-bit DS3, G.751 E3, or G.832 E3 data streams. Unused functions can be powered down to reduce device power. The DS317x DS3/E3 SCTs conform to the telecommunications standards listed in Section 4.
 

Data Sheet

Download this datasheet in PDF formatDownload Rev 2 (PDF, 1.7MB)
Send this datasheet to any email addressE-Mail

Errata DS3171 317XA2.pdf
Errata DS3172 317XA2.pdf
Errata DS3173 317XA2.pdf
Errata DS3174 317XA2.pdf
An evaluation kit is available: DS3174DK

Key Features

  • Single (DS3171), Dual (DS3172), Triple (DS3173), or Quad (DS3174) Single-Chip Transceiver for DS3 and E3
  • All Four Devices are Pin Compatible for Ease of Port Density Migration in the Same Printed Circuit Board Platform
  • Each Port Independently Configurable
  • Performs Receive Clock/Data Recovery and Transmit Waveshaping for DS3 and E3
  • Jitter Attenuator can be Placed Either in the Receive or Transmit Paths
  • Interfaces to 75Ω Coaxial Cable at Lengths Up to 380 meters, or 1246 feet (DS3) or 440 meters, or 1443 feet (E3)
  • Uses 1:2 Transformers on Both Tx and Rx
  • On-Chip DS3 (M23 or C-Bit) and E3 (G.751 or G.832) Framer(s)
  • Ports Independently Configurable for DS3, E3
  • Built-In HDLC Controllers with 256-Byte FIFOs for the Insertion/Extraction of DS3 PMDL, G.751 Sn Bit, and G.832 NR/GC Bytes
  • On-Chip BERTs for PRBS and Repetitive Pattern Generation, Detection, and Analysis
  • Large Performance-Monitoring Counters for Accumulation Intervals of at Least 1 Second
  • Flexible Overhead Insertion/Extraction Ports for DS3, E3 Framers
  • Loopbacks Include Line, Diagnostic, Framer, Payload, and Analog with Capabilities to Insert AIS in the Directions Away from Loopback Directions
  • Ports can be Disabled to Reduce Power
  • Integrated Clock Rate Adapter to Generate the Remaining Internally Required 44.736MHz (DS3) and 34.368MHz (E3) from a Single Clock Reference Source at One of Three Standard Frequencies (DS3, E3, STS-1)
  • Pin Compatible with the DS318x Family of Devices and the DS316x Family of Devices
  • 8-/16-Bit Generic Microprocessor Interface
  • Low-Power (~1.73W) 3.3V Operation (5V Tolerant I/O)
  • Small High-Density Thermally Enhanced Chip- Scale BGA Packaging (TE-CSBGA) with 1.27mm Pin Pitch
  • Industrial Temperature Operation: -40°C to +85°C
  • IEEE1149.1 JTAG Test Port
 

Applications/Uses

  • Access Concentrators
  • Digital Cross Connect
  • Integrated Access Device (IAD)
  • Multiservice Access Platform (MSAP)
  • Multiservice Protocol Platform (MSPP)
  • PBXs
  • PDH Multiplexer/Demultiplexer
  • Routers and Switches
  • SONET/SDH ADM and Muxes
  • Test Equipment
   

Key Specifications:

T/E Carrier & Packetized Products
Part Number Transmission Standard Functions Channels VSUPPLY
(V)
EV Kit Package/Pins Smallest Available Pckg.
(mm2)
Budgetary Price
max w/pins See Notes
DS3171  T3/E3 Framer + LIU 1 3.3 -
PBGA/400
729 $47.38 @1k
DS3172  2 -
PBGA/400
-
DS3173  3 -
PBGA/400
-
DS3174  4 Yes
PBGA/400
-
See All T/E Carrier & Packetized Products (100)
Pricing Notes:
This pricing is BUDGETARY, for comparing similar parts. Prices are in U.S. dollars and subject to change. Quantity pricing may vary substantially and international prices may differ due to local duties, taxes, fees, and exchange rates. For volume-specific prices and delivery, please see the price and availability page or contact an authorized distributor.


Diagram

DS3171, DS3172, DS3173, DS3174: Functional Diagram
Functional Diagram

Application Notes

Application Note 3410   Guidelines for Laying Out T3 and E3 Network Interfaces
Application Note 3547   Measuring Return Loss on T3/E3/STS-1 LIUs
Application Note 3609   Clock-Rate-Adapter (CLAD) Features for DS325X, DS316X, DS317X, and DS318X
Application Note 3670   Measuring Return Loss Using the Advantest R3132 Spectrum Analyzer
Application Note 3763   Measuring and Improving Return Loss on the DS317x and DS318x T3/E3/STS-1 LIUs

Product Guides

Communications (PDF)

Reliability Reports

Reliability Report: DS3171.pdf DS3172.pdf DS3173.pdf DS3174.pdf

Software/Models

DS3171 A2 BSDL Model
DS3171 IBIS Model
DS3172 A2 BSDL Model
DS3172 IBIS Model
DS3173 A2 BSDL Model
DS3173 IBIS Model
DS3174 A2 BSDL Model
DS3174 IBIS Model

Ordering Information

Filters: Part Number: Package: Temperature: Tape and Reel Sample
Part Number Free
Sample
Buy Status Explanations for product status codes Recommended Replacement Package:
TYPE PINS FOOTPRINT
DRAWING  CODE/VAR *
Temp RoHS/Lead-Free?
Materials Analysis
DS3171    
Active   PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T-2*
0°C to +70°C See data sheet
DS3171N    
Active   PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T-2*
-40°C to +85°C See data sheet
DS3171N+  
Active   PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T+2*
-40°C to +85°C RoHS/Lead-Free: Lead Free
Materials Analysis
DS3172    
Active   PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T-2*
0°C to +70°C See data sheet
DS3172+    
Active   PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T+2*
0°C to +70°C RoHS/Lead-Free: Lead Free
Materials Analysis
DS3172N    
Active   PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T-2*
-40°C to +85°C See data sheet
DS3172N+  
Active   PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T+2*
-40°C to +85°C RoHS/Lead-Free: Lead Free
Materials Analysis
DS3173    
Active   PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T-2*
0°C to +70°C See data sheet
DS3173N    
Active   PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T-2*
-40°C to +85°C See data sheet
DS3174    
Active   PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T-2*
0°C to +70°C See data sheet
Part Number Free
Sample
Buy Status Explanations for product status codes Recommended Replacement Package:
TYPE PINS FOOTPRINT
DRAWING  CODE/VAR *
Temp RoHS/Lead-Free?
Materials Analysis
DS3174+    
Active DS3174N+

 
PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T+2*
0°C to +70°C RoHS/Lead-Free: Lead Free
Materials Analysis
DS3174N    
Active   PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T-2*
-40°C to +85°C See data sheet
DS3174N+  
Active   PBGA;400 pin;729 mm²
Outline Drawing:21-0306 (PDF)
Land Pattern: 90-0266 (PDF)
Use pkgcode/variation: V400T+2*
-40°C to +85°C RoHS/Lead-Free: Lead Free
Materials Analysis

Notes:
  1. Other options and links for purchasing parts are listed at: http://www.maxim-ic.com/sales.
  2. Didn't Find What You Need? Ask our applications engineers. Expert assistance in finding parts, usually within one business day.
  3. Part number suffixes: T or T&R = tape and reel; + = RoHS/lead-free; # = RoHS/lead-exempt; -D = drypack; -U/+U on DS parts = cut tape. More: See Full Data Sheet or Maxim Product Naming Conventions.
  4. * Some packages have variations, listed on the drawing. "PkgCode/Variation" tells which variation the product uses. Note that "+", "#", "-" in the part number suffix describes RoHS status. Package drawings may show a different suffix character.

Similar Products by Function

See All T/E Carrier & Packetized Products (103 Products)

Similar Products by Application

Telecom Line Cards: T3, E3, STS-1 > Single-Chip Transceivers with or without ATM/Packet PHY
Telecom Switches (PBX and Central Office) > T3/E3 Products
Transport Nodes, Access Nodes, Add/Drop Multiplexers, and Digital Cross-Connects > T3/E3 Products

Evaluation Kits

DS3174DK DS3/E3 Single-Chip Transceiver Demo Kit

Products with Similar Part Numbers

DS3174DK DS3/E3 Single-Chip Transceiver Demo Kit

More Information

New Product Press Release 2005-03-29 ]


Didn't Find What You Need?

Information Index

Rev 2; 2006-12-14
This page last modified: 2009-10-07


 


Contact Us     |     Privacy Policy     |     Legal Notices
Copyright © 2012 by Maxim Integrated Products